FOR ADVICE, REPAIRS ANDFAST SERVICE1300 367 565MODELS G26 Pure 6INSTRUCTIONSINSTALLATION AND OPERATINGEXTERNAL GAS HOT WATER UNIT20637894 (K)
8COLD WATER CONNECTIONSTOP TAPS OR COMBINATION STOP TAPS ANDNON-RETURN VALVES ARE NOT TO BE USED!1.9 COLD WATER SUPPLY TO WATER HEATERRefer to the T
9HOT WATER CONNECTION3.0 The appliance is equipped with a three pinned earthed plug to be connected to a 220- 240V 50Hz power supply. The ele
10WIRING DIAGRAM AND REMOTE CONTROLS INSTALLATION SCHEMATICPYBKGBLORGYBRWWWWWWWWWWBRBLGGPROTECTOR(5A)SURGE12FUSE11AC240VW: Purple: Yellow: Black: Gree
11REMOTE CONTROLSRefer to Technical Sheets4.0 The ETERNITY G26 Pure 6 comes complete, with one, two or three remote control panels, as opti
12REMOTE CONTROLSCMR-2251(Main remote Controller)This remote controller is intended to be used in the kitchen, laundry room or utility area.YST-2251/S
13MOUNTING ROMOTE CONTROLSMOUNTING AND WIRING OF REMOTE CONTROLS4.7 REMOTE CONTROLSOPEN THE CARTON BOX AND MAKE SURE TO CHECK FOLLOWING PARTSPROVID
14MOUNTING REMOTE CONTROLS1) Safety precautions on Main remote controller installation. • Connect remote controller cable after heater is unplugge
15MOUNTING REMOTE CONTROLS1) Safety precautions on Bath remote controller / Ensuite installation. • Before remote controller installation, check t
16USER INSTRUCTIONSOperation of Main / Bath remote controller / Ensuite.Please read these instructions carefully before using this appliance.1. Turn o
171. Set the MAIN CONTROL to 42℃ for normal household use and to prevent small children from scalding.2. For the dishwasher set the MAIN CONTROL to
INDEXINSTALLATION INSTRUCTIONS PAGE NO.IntroductionDimensions ConnectionsExploded DiagramTe c hnical DataGas ConnectionCold Water ConnectionHot Water
18CARE OF THE ETERNITY HOT WATER UNIT6. IF A POWER FAILURE OCCURS THE REMOTE CONTROLS WILL NOT FUNCTION AND THE ETERNITY UNIT WILL NOT SUPPLY HOT W
19HINTS FOR USING THE ETERNITY UNITPOINTS NEEDED FOR YOUR SPECIAL ATTENTIONDangerNO INSTALLATION INDOORS(May cause oxygen deficiency accident or incom
20WarningNO DISASSEMBLY, REPAIR ORMODIFICATION(May cause fire, electric shock orother accidents.)Do not disassemble or modify the units.Never fail to
21WarningCAUTION TO PREVENT SCALDINGCautionCheck the water temperature by hand first before using shower.MEASURE TO BE TAKEN IN CASE OF EMERGENCYWhen
22CautionDANGER OF WET HANDS(May cause electric shock.)Do not touch power plug with wet hands.It is dangerous, because it can causeelectric shock.INSE
23CautionCONFIRM IGNITION, COMBUSTION AND EXTINCTIONPlease always check ignition, combustion and extinction of the unit by the operation lampof the ma
24FAULT MONITORTHE ETERNITY HOT WATER UNIT HAS A SELF DIAGNOSING FUNCTION FOR FAULTS.FAULT MONITORWhen the unit does not operate correctly an error co
25Eternity Continuous Flow1. All Eternity water heaters must be installed by a Licensed installer.2. Only Authorised personnel must Install, Commissio
Warranty TermsEternity Water Heaters are covered by Eternity for any cost of labour and parts in the event ofa component failure due to any defects t
1INTRODUCTIONETERNITY G26 Pure 6INSTALLATION INSTRUCTIONSINTRODUCTIONThe ETERNITY G26 Pure 6 is an external electronic gas hot water heater.The ETERNI
2DIMENSIONS CONNECTIONS128122165156235691357535050 50585330308COLD WATER INLETR3/4 /20WATER INLET FILTERPRESSURE RELIEF VALVEGAS SUPPLY INLETR3/4 /20H
3EXPLODED DIAGRAMFLUE OUTLETGAS VALVECIRCUIT BOARDBURNER CASEHOT WATER OUTLETCOLD WATER INLETGAS SUPPLY INLETHEAT EXCHANGERWATER VOLUMEPROPORTIONAL VA
4TECHNICAL DATA1.1 TECHNICAL DATA AND DIMENSIONS ETERNITY G26 Pure 6Nominal hourly gas consumption MJ/hby proportional electronic gas controlTest po
5TECHNICAL DATA1.4 HEATER DIMENSIONS:DEPTHWIDTHHEIGHT1.5 WARNING LABELSLocated on the side of the cabinet.PLEASE READ THESE LABELS CAREFULLY.1.7
6TECHNICAL DATAAS 5601 CLEARANCE REQUIREMENTS.NOTES:1 All distances are measured to the nearest part of the terminal.2 Prohibited area below electri
7GAS CONNECTIONSERVICE CALLS ARE CHARGEABLE FORUNITS WITH INCORRECT GAS PIPE SIZES.1.8 GAS CONNECTION(1) Fit a union to the water heater gas inlet f
Comments to this Manuals